My end play on the crank before putting in new mains was 0.4mm and the max is 0.38. Should I use locktite on these just to make sure. The old nuts were slotted at the ends almost like how a collet is slit. The old ones were quite tight,like a 100% fit whereas the new ones just look like a normal nut and are quite loose,like a 50% thread fit. What type of reamer would be used? Should the con rod bolts be replaced? The con rod bolts that were in the engine are very different to the new ones I have bought. How are the conrod small ends bored,or reamed. Thats why I am hoping to get some advice from the guys on this forum. The reason it is so far is that the farm is in the Cradle of human kind and I live in Durban by the sea on the east coast of Africa.My neighbor is the lion park where the dude on National geographic likes to cuddle his lions.I have limited time on the farm so I have decided to bring the engine home with me and fix it at my leisure.Hopefully if I get it right at least I know what i have done and what has gone in this tractor.By the time the tractor is up and running I would have done 2800km, so hopefully I dont do any thing wrong.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |